- 28 -
in RIP v2 format using subnet broadcasting. If RIP v1 Compatible is selected, routing data will be
sent in RIP v2 format using multicasting.
To enable Dynamic Routing, click Advanced and under Advanced, select Dynamic Routing.
Figure 18 illustrates a typical Dynamic Route.
Figure 18 (Dynamic Routing)
The Apply button will temporarily save this connection. To make the change permanent, you
need to click on Save Settings (at the side of the page). At the system commands page, click on
Save All.
4.7 Tools
The ADSL router supports a host of tools that will allow you to customise and debug the ADSL
router.

4.7.1 System Commands

To make the changes permanent, you need to click on Tools (at the top of the page) and select
System Commands. The following commands are used to configure the gateway:
a. Save all: Click this button in order to permanently save the current configuration of the
ADSL router. If you do restart the system without saving your configuration, the ADSL
router will revert back to the previously saved configuration.
b. Restart: Use this button to restart the system. If you have not saved your
configurations, the ADSL router will revert back to the previously saved configuration
upon restarting.
NOTE: Connectivity to the unit will be lost. You can reconnect after the unit reboots.
c. Restore Defaults: Use this button to restore factory default configurations.
NOTE: Connectivity to the unit will be lost. You can reconnect after the unit reboots.