AT-PC232/POE Media Converter Installation Guide
45
Installing the Power Cord Retaining Clip
Perform the following procedure to install the power cord retaining clip on
the AT-PC232/POE Media Converter:
1. Locate the power cord retaining clip, shown in Figure 12 in the
shipping kit that comes with the media converter.
Figure 12. Power Cord Retaining Clip
2. Install the clip on the AC power connector on the back panel of the
switch. With the “u” of the clip facing down, press the sides of the clip
toward the center and insert the short ends into the holes in the
retaining bracket, as shown in Figure 13.
Figure 13. Inserting the Retaining Clip into the Retaining Bracket
1 2 3 4
10
100
SPEED
(Mbps)
OFF
ON
AUTO
NEG
HALF
FULL
DUPLEX
MODE
2PORT
122 100-240VAC
~
1379
1 2 3 4
10
100
SPEED
(Mbps)
OFF
ON
AUTO
NEG
HALF
FULL
DUPLEX
MODE
2PORT
122
100-240VAC
~
1380