Allstar Products Group 831E Commercial Receiver Wiring Instructions, Before Wiring Permanently

831E COMMERCIAL RECEIVER WIRING INSTRUCTIONS

WARNING	IMPROPER WIRING COULD CAUSE ELECTROCUTION OR DAMAGE TO CIRCUITRY.
	FOLLOW LOCAL BUILDING AND ELECTRICAL CODES.
WARNING	TO PREVENT ELECTROCUTION DISCONNECT POWER AT FUSE BOX AND DOOR OPENER
	BEFORE WIRING PERMANENTLY.

The 831E receiver functions as a 3-button station. Three sets of isolated contacts are provided; normally open contacts for the OPEN PUSHBUTTON (orange wires); normally open contacts for the CLOSE PUSHBUTTON (black wires); normally closed contacts for the STOP PUSHBUTTON (gray wires). Refer to Figure 1. For special STOP circuit applications, normally open contacts are available from the factory.

WALL PUSHBUTTON STATION	Typical 4-wire 3-button stations are wired as
105113	shown in Figure 2. Number 18 gauge wire
	or heavier must be used for wiring the
OPEN	control stations and the 831E receiver to the
	door operator. Smaller gauge wire may
OPERATORTO TERMINALSTRIP			CLOSE
	mounted near the door operator, away from OPEN
	cause operational problems, especially when				A	R	O
CLOSE	multiple 3-button stations are	used. For	E	NG
	typical installations the 831E	receiver is
STOP	any high voltage conduits or steel support
	beams. For wiring, follow the steps below
Figure 2	and refer to Figure 3.

BLACK

G

R

A

Y

STOP

R	E	D
		H	I	T	E
	W

24 VAC

1.In the door operator control panel, locate the wire connecting the door operator to the 3-button station COMMON. Note its location and remove.

2.Connect one of the gray wires from the 831E to the wire just removed from the pushbutton COMMON.

3.Connect the following wires from the 831E to the operator 3-button COMMON (as shown at right):

ONE ORANGE (OPEN)

ONE BLACK (CLOSE)

ONE GRAY (STOP)

4.Connect the remaining 831E black wire to the CLOSE pushbutton terminal in the door operator control panel.

106549

Step 5

				WALL PUSH
	Step 3			BUTTON
		COMMERCIAL		STATION
MVP831E-831E		OPERATOR		OPEN
				Step 4
RECEIVER
		STOP COM	OPEN CLOSE	CLOSE
				STOP
				COMMON
	ORANGE
	BLACK
	GRAY
	BLACK
	GRAY	Step 2		Figure 3
	ORANGE
RED WHITE			Removed Wire
			(See Step 1)
24 VAC	Step 6

5.Connect the remaining 831E orange

wire to the OPEN pushbutton terminal in the door operator control panel.

6.Finish the wiring by connecting 24 VAC to the red and white wires of the 831E receiver.

BEFORE APPLYING POWER, CHECK ALL CONNECTIONS AND INSTALL THE ANTENNA.

	DO NOT USE RADIO CONTROLS ON COMMERCIAL DOOR OPERATORS UNLESS PROPER
	ENTRAPMENT PROTECTION DEVICES ARE INSTALLED. CONSULT THE MANUFACTURER OF
WARNING	YOUR OPERATOR FOR MORE DETAILS.

Page 2 of 4 P/N 106547 REV D