Basic Operation
|
|
|
|
|
|
| MODE | ||
POWER BAND | 2 | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
g DN 
f UP 1 SETUP
Detaching the Front Panel
1 Press the POWER button for more than 3 seconds to turn off the power.
2 Press the 
(Release) button at lower left corner until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
Initial System Start-Up
Immediately after installing or applying power to the unit, it should be initialized. To do this, first, remove the detachable front panel. Behind the front panel, to the right of the connector, there is a small hole. Using a pencil or other pointed object, press the red reset switch mounted behind this hole to complete the initialization procedure.
NOTES
∙The front panel may become hot in normal usage (especially the connector terminals), this is not malfunction.
∙To protect the front panel, place it in the supplied carrying case.
Attaching the Front Panel
1 First, insert the right side of the front panel into the main unit. Align the 2 small holes on the front panel with the 2 projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
2 |
1 |
1
Reset switch
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except the eject c button.
The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press the POWER button for more than 3 seconds to turn off the unit.
NOTE
The very first time the power is turned on, the volume will start from level 12, the BBE will be on in the tuner mode*, and the LOUD function will be on**.
*
**
NOTE
Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
