Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc.
1 Turn off the unit power.
2 Press (OPEN) to open the front panel, then remove it.
3 Press RESET with a ballpoint pen or similar pointed object.
Radio
Rotary | SOURCE/POWER | |||||||||
encoder |
| BAND | TUNE/A.ME | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
MODE | FUNC. Preset buttons |
| (1 through 6) |
RESET switch
Adjusting Volume
Turn the Rotary encoder until the desired sound is obtained.
Controllable With Remote Control
The
Remote control sensor
Connectable to Remote Control Interface Box
You can operate this unit from the vehicle’s control unit when an Alpine Remote Control Interface Box (optional) is connected. For details, contact your Alpine dealer.
Listening to Radio
1 Press SOURCE/POWER until a radio frequency appears on the display.
2 Press BAND repeatedly until the desired radio band is displayed.
F1 (FM1) F2 (FM2) F3 (FM3) MW LW F1 (FM1)
3 Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode) SEEK (Local mode) OFF (Manual mode) DX SEEK
•The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in (Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4 Press or to tune in the desired station.
Holding down or will change the frequency continuously.
Manual Storing of Station Presets
1 Select the radio band and tune in a desired radio station you wish to store in the preset memory.
2 Press and hold, for at least 2 seconds, any one of the preset buttons (1 through 6) into which you wish to store the station.
The selected station is stored.
The display shows the band, preset number and station frequency memorized.