Antenna Receptacle
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
•This lead should be used only for controlling the vehicle’s power antenna. Do not use this lead to turn on an amplifier, or a signal processor, etc.
Remote
Connect this lead to the remote
Audio Interrupt In Lead (Pink/Black)
Illumination Lead (Orange)
This lead may be connected to the vehicle’s instrument cluster illumination lead. This will allow the backlighting of the
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
Power Supply Connector
Right Front (+) Speaker Output Lead (Gray) Right Front
Left Rear (+) Speaker Output Lead (Green)
Left Rear
Fuse Holder (10A)
Ai-NET Connector
Connect this to the output or input connector of another device (CD Changer, Equalizer, HD Radio™ TUNER MODULE, etc.) equipped with
•Be sure to set “Setting the Connected Head Unit (MODEL SETUP)” to “DVD CHG”, when the
•Interface adapter for iPod
Steering Remote Control Interface Connector
To steering Remote control interface box.
For details about connections, consult your nearest Alpine dealer.
Rear Output/Input RCA Connectors
It can be used as Rear Output or Input RCA Connectors. RED is right and WHITE is left.
Front Output/Input RCA Connectors
It can be used as Front Output or Input RCA Connectors. RED is right and WHITE is left.
Subwoofer RCA Connectors
RED is right and WHITE is left.
RCA Extension Cable (sold separately)
BLUETOOTH Interface Connector
Connect this to an optional BLUETOOTH INTERFACE
To use a
System Switch
When connecting a processor or divider using
•When the IMPRINT audio processor is connected, set to EXT AP position.
•Be sure to turn the power off to the unit before changing the switch position.
USB Connector
Connect USB cable.
USB cable
Connect this to a USB memory/Portable audio player or to an iPod/iPhone. To use an iPod/iPhone, iPod Dock interface cable connection is required.
•Use the supplied USB cable. If a USB cable other than the supplied is used, correct performance cannot be guaranteed.
•Route the USB cable away from other cables.
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
