Alpine TCS-V430A owner manual Operation AV Control Functions

OPERATION - AV Control Functions

For example:

1)While viewing 2ND monitor, Press and Hold Monitor 2ND key [A] (assume it is currently displaying the TV video)

2)The Monitor connected to the 2ND output will display:

3)Before the OSD turns off, Press the 2ND key again to [B] change the source for MONITOR2 to DVD. Each successive press will change the source to VCR, then AUX and finally back to TV. Or, pressing any of the Direct Source selection keys will also change source.

A. . . B

B

MONITOR1 : DVD

MONITOR2 : TV

MONITOR3 : AUX

PRESS MONITOR KEY THEN PRESS AV SOURCE KEY

MONITOR1 : DVD

MONITOR2 : DVD

MONITOR3 : AUX

PRESS MONITOR KEY THEN PRESS AV SOURCE KEY

This line will be

blinking

This line will be

blinking

4)Press any of the other Monitor keys to change the AV output. If the 3RD Monitor Output is pressed [A], the MONITOR3 line in the menu will blink. Change the source for this monitor as previously described. Either Direct Source or Cyclic selection is available for each Menu item.

A

NOTE:

MONITOR1 : DVD

MONITOR2 : TV

MONITOR3 : AUX

PRESS MONITOR KEY THEN PRESS AV SOURCE KEY

This line will be

blinking

	When using non-Alpine AV products, it is possible to select an output that is not connected or ON.
	When this happens, the monitor currently being viewed will be unable to perform any functions until
	the OSD is turned off on the other monitor. Pressing the SOURCE key will turn off the Menu
8	immediately (before the 8 second delay).