OPERATION - AV Control Functions
Audio Gain Adjust
The audio level for each AV input (4 total) can be adjusted individually. This will compensate for the inherent differences in output level for the various sources connected to the controller.
Entering “Input Level Setting” screen
Press and hold the “TV” Power button [ A].
The “Input Level Setting” screen will be displayed on all connected monitors (as shown below).
A | INPUT LEVEL SETTING |
| |
| Ð | O | + |
TV O
DVD O
VCR O
AUX O
NOTE: This OSD will remain active indefinitely, until the user manually turns it off.
•AV Source Selection
Initially, the TV source blinks in the OSD. This indicates the active source. Any adjustment applies to the active source only. To select another
source, use the AUTO CH buttons [A] to move up or down in the menu. In addition, pressing any of the AV SOURCE buttons will activate its corresponding source directly.
For example (assume TV is blinking):
1) Press the AUTO CH UP button and AUX starts blinking
2) Press the DVD button and DVD in the Menu starts blinking
• Level Adjust
Once the Source has been selected, use the MANUAL SEEK buttons [B] to adjust its Level up or down.
A
B
As the level is adjusted, the bar centered at zero (default) will extend to either the positive or negative direction. At the same time, the numerical indicator (initially 0) will either increase (maximum = 7) or decrease (minimum =
Listen to each output and match levels according to your personal preferences.
NOTE:
Any button, besides the ones used in the adjustment process, can be pressed to leave the Level Adjustment screen.
9
