![](/images/new-backgrounds/1120825/12082537x1.webp)
MULTITASKER
7.4.5 MENU MODE EXAMPLES
All Menu Mode examples assume an
1. Set Video Equalization
Follow the keystrokes below to set the video equalization for Input 1 to 16 with a starting level of 12.
Enter | List available cards |
03 | Select |
1Select EQUALIZATION CONTROL The current gain level will be displayed in the menu, for example 12.
1Select INPUT #1 for adjustment
1111 Select increment 4 times
After each increase, the new level will be displayed in the menu.
ESC | Return to EQUALIZATION Menu |
ESC | Return to the Main Menu |
2. Display Card Status
Starting from the
6 | Display card status |
NOTE: The status will be displayed, followed by the Main Menu being redisplayed.
TROUBLESHOOTING GUIDE | 8 |
We have carefully tested and found no problems in the supplied
8.1 LEDs ARE OFF
Cause 1: There is no power to the card.
Solution 1: Make sure the card is plugged all the way into the enclosure. If an LED is still not on, see Cause 2.
Cause 2: The card is not initialized.
Solution 1: Turn the system power off and then back on again. If one of the LEDs is still not on, please call ALTINEX at
(714)
8.2DISPLAY IS TOO BRIGHT
Cause 1: The software gain is too high.
Solution: Set the gain control to 1 using the
Cause 2: The gain switch is not set correctly.
Solution: Set the gain control switch to the HW (hardware) position for a fixed gain of one. If the display is still too bright, see Cause 3.
Cause 3: The receiver video gain is too high.
Solution: Set the gain control switch to the HW (hardware) position for a fixed gain of one. If the display is still too bright, please call ALTINEX at
(714)
8.3NO DISPLAY
Cause 1: The source has a problem.
Solution: Check the source and make sure that there is a signal present and all source connections are correct. If the source is working and there is still no display, see Cause 2.
18 |