SWITCHERS
FREQUENTLY ASKED QUESTIONS | 9 |
MX2214RM
universal internal power
No:
1
2
3
4
5
Question
When I press F1 nothing happens. What is the purpose of this function?
What is the LED next to the F1 button used for?
Why when I press the
RESET button, the switcher does not respond. Why?
Can the
MX2214RM be rack mounted?
Can the
Answer
The F1 function is reserved for future use. It does not perform any functions at the present time.
This LED is also reserved for future use. It is currently non- operational.
You must press and hold the button for approximately 2 seconds, until you hear a beeping sound and all of the LED lights flash. This is designed to avoid accidental resetting.
The MX2214RM can be rack mounted by itself or with two units side by side. The width of the unit is 1/2 rack wide.
Altinex offers rack mount ears for single unit mounting (part# DA1299RM) and rack shelf for two unit mounting (part# DA1298RM).
Yes, simply use the
Switcher be used outside of the United States
7How do I control several switchers with one
8May I use contact closure to control the switcher?
9Can this switcher be looped with other
MX2214RM
Switchers?
supply, enabling it to be used throughout the world. Please make sure to have the voltage setting in the correct position and please make sure to use the proper adapter cable for the country where it will be used. Adapter cables for several countries are available through Altinex.
You can control multiple switchers with one card at this time. The unit has ID codes and can be differentiated by the control system. Call Altinex at
A special cable that plugs into the
Yes, in exactly the same way as described in section 7.3 this manual.
6
MX2214RM
be used to pass Composite Video, S- Video or Component Video?
Can the
corresponding channels to pass the signals (e.g. For composite video, you may use the red input channel and the red output channel, or you can use the blue input channel and blue output channel). Since the MX2214RM is a relay switcher, it can be used as a contact closure control or to switch virtually any type of video signal.
Yes, the MX2214RM uses a
TROUBLESHOOTING GUIDE | 10 |
∙Please make sure, that input signal formats are the same for the input (source) and output (display).
∙Please make sure that input signal amplitude levels are as follows:
∙RED, GREEN, and BLUE are less than 10 V.
∙SYNC is less than 1.0 V and more than 0.3 V.
∙Please use the appropriate input voltage 110 VAC or 220 VAC.
11
