Altinex VA6834FC manual FAQ Frequently Asked Questions

INTERFACES

CB5100PL- 5BM01005BM

CB5100PL- 5BM01505BM

CB5100PL- 5BM02005BM

CB5100PL- 5BM02505BM

100 ft, 5-BNC M to 5-BNC M

150 ft, 5-BNC M to 5-BNC M

200 ft, 5-BNC M to 5-BNC M

250 ft, 5-BNC M to 5-BNC M

5

separate sync from green?

When do I use the

H & V OUT dip-switch?

If the desired output is in RGBHV format, turn ON the H & V OUT dip-switch. If the H & V OUT dip-switch is OFF, then the output signal may have composite sync present on the

All MS81 series cables listed on the previous page are 3 ft. long. These are available in 6 ft. and 12 ft. lengths. Please call 1-714-990-2300 for a wider selection of cables.

FAQ (FREQUENTLY ASKED QUESTIONS) 9

6

What is a Common Computer Video Card pin-out?

horizontal sync connector.

See table 5 for pin-outs for common computer video cards that can be used with the VA6834FC.

No: Question

1Why does the termination switch have to be ON?

2When and why should I use the Horizontal Position Control dial?

3What dip- switch do I set to obtain composite

SYNC output?

4When and why would I use the sync on green dip- switch, although the unit does not

Answer

The termination switch should be ON if a local monitor is connected through a straight cable. It will be OFF only if a monitor breakout cable is used at the local monitor output connector.

The Horizontal Position Control dial enables or disables the control of the horizontal position of the image. First, adjust the horizontal position using the monitor or projector’s control. Then use the horizontal Position Control of the VA6834FC, if needed.

If the desired output signal is composite sync, then turn OFF the H & V OUTPUT Dip-switch and connect only 4 wires (RGBS) to the red, green, blue and sync connectors.

The VA6834FC does not separate the sync signal from green. If the desired output is in RGsB format, turn the sync on green dip-switch to the ON position. The VA6834FC combines sync on green if the dip-switch is in the ON position.

11