Alto-Shaam HFT2SYS-300, HFT2-400 DANGeR, electric a l connection, D A N G e R, ins ta l l at io n

ins ta l l at io n

electric a l connection

The appliance must be installed by a qualified service technician. The oven must be properly grounded in accordance with the National Electrical Code and applicable local codes.

D A N G e R

to avoid electrical shock, this appliance mUSt be adequately grounded in accordance with local electrical codes or, in the absence of local codes, with the current edition of the national electrical Code anSi/ nFpa no. 70. in Canada, all electrical connections are to be made in accordance with CSa C22.1, Canadian electrical Code part 1 or local codes.

Plug the unit into a properly grounded receptacle ONLY, positioning the unit so that the plug is easily accessible in case of an emergency. Arcing will occur when connecting or disconnecting the unit unless all controls are in the “off” position.

Proper receptacle or outlet configuration or permanent wiring for this unit must be installed by a licensed electrician in accordance with applicable local electrical codes.

ELECTRICAL - HFT2-300

voltage	phase	cycle/hz	amps	kW	cord & plug
208-240 (agcy) 1		60	13.6	3.3	NEMA 6-15P
at 208	1	60	11.8	2.5	15A - 250V Plug
at 240	1	60	13.6	3.3
230	1	50	13.0	3.0	cee 7/7,
					220-230v plug
ELECTRICAL - HFT2-400
voltage	phase	cycle/hz	amps	kW	cord & plug
208-240 (agcy) 1		60	13.7	3.3	NEMA 6-20P
at 208	1	60	11.9	2.5	20A - 250V Plug
at 240	1	60	13.7	3.3
230	1	50	13.1	3.0	cee 7/7,
					220-230v plug

DANGeR

eleCtRiCal COnneCtiOnS mUSt be made bY a QUaliFied SeRviCe teCHniCian in aCCORdanCe WitH appliCable eleCtRiCal COdeS.

DANGeR

enSURe pOWeR SOURCe matCHeS vOltage Stamped On applianCe nameplate.

REGARDING INTERNATIONAL STANDARD UNITS:

If the unit is not equipped with flexible cord with plug, an all-pole country approved disconnection device which has a contact separation of at least 3mm in all poles must be incorporated in the fixed wiring for disconnection. When using a cord without a plug, the green/yellow conductor shall be connected to the terminal which is marked with the ground symbol. If a plug is used, the socket outlet must be easily accessible. If the power cord needs replacement, use a similar one obtained from the distributor.

For CE approved units: To prevent an electrical shock hazard between the appliance and other appliances or metal parts in close vicinity, an equalization-bonding stud is provided. An equalization bonding lead must be connected to this stud and the other appliances / metal parts to provide sufficient protection against potential difference. The terminal is marked

with the following symbol.

ELECTRICAL - HFT2-500

voltage phase cycle/hz amps kW cord & plug

208-240 (agcy) 1		60	15.7	3.8
at 208	1	60	13.6	2.8
at 240	1	60	15.7	3.8

NEMA 6-20P

20A - 250V Plug

230 1 50 15.0 3.5 cee 7/7,

220-230v plug

Wire diagrams are included in the literature

package supplied with the unit..

HFT2 INSTALLATION/OPERATION/SERVICE MANUAL • 9..