Alto-Shaam HFT2SYS-300 manual ins ta l l at io n, site INSTALLATION, Site Installation, Leveling

ins ta l l at io n

site INSTALLATION

D A N G e R

impROpeR inStallatiOn, alteRatiOn, adJUStment, SeRviCe, OR maintenanCe COUld ReSUlt in SeveRe inJURY, deatH, OR CaUSe pROpeRtY damage.

Read tHe inStallatiOn, OpeRating and maintenanCe inStRUCtiOnS tHOROUgHlY beFORe inStalling OR SeRviCing tHiS eQUipment.

C A u t i O N

metal paRtS OF tHiS eQUipment beCOme eXtRemelY HOt WHen in OpeRatiOn. tO avOid bURnS, alWaYS USe Hand pROteCtiOn WHen OpeRating tHiS applianCe.

C A u t i O N

tO pRevent peRSOnal inJURY, USe CaUtiOn WHen mOving OR leveling tHiS applianCe.

C A u t i O N

The performance of this unit has been optimized using the factory provided bulbs. These bulbs should be replaced with an exact replacement or with a factory recommended replacement. These bulbs have been treated to resist breakage and must be replaced with similarly treated bulbs in order to maintain compliance with NSF standards. DO NOT over-tighten bulbs in their receptacles as this can cause damage to the bulb filament.

SITE INSTALLATION

In order to maintain established National Sanitation Foundation standards, all stationary floor models must be sealed to the floor with a R.T.V. or silastic meeting N.S.F. requirements or have 6" (153mm) unobstructed clearance beneath the unit.

1. The appliance must be installed on a stable and level surface.

2.DO NOT install this appliance in any area where it may be affected by any adverse conditions such as steam, grease, dripping water, high temperatures, or any other severely adverse conditions.

3.DO NOT install a heated display case near a cold air source such as a freezer, air conditioning vents, or in any area where outside air fluctuation can affect performance.

4.This appliance must be kept free and clear of any obstructions blocking access for maintenance or service.

A number of adjustments are associated with initial installation and start-up. It is important that these adjustments be conducted by a qualified service technician. Installation and start-up adjustments are the responsibility of the dealer or user. These adjustments include but are not limited to thermostat calibration, door adjustment, leveling, electrical hook-up and installation of optional casters or legs.

LEVELING

Level the appliance from side-to-side and front-to-back with the use of a spirit level.

We recommend checking the level periodically to make certain the floor has not shifted nor the appliance moved.

NOTE: Failure to properly level this appliance can cause improper function.

HFT2 INSTALLATION/OPERATION/SERVICE MANUAL • 3..