Care and Cleaning (cont’d)
!WARNING
To avoid risk of burns or electrical shock:
•disconnect electrical supply to oven before changing light bulb.
•before replacing light bulb make sure oven and bulb are cool.
•Do not operate oven without bulb and cover in place.
Replacing Oven Light
1.Disconnect electrical supply.
2.Remove oven door if desired.
3.While wearing protective gloves, unscrew counter clockwise the light bulb cover located in rear of oven cavity.
Then turn light bulb counterclockwise to remove.
4.Replace light bulb with
Do not over tighten bulb or cover or they may be difficult to remove later.
5.Replace light bulb cover and oven door before use.
6.Reconnect power supply.
! CAUTION
To avoid risk of personal injury, Wear gloves to protect hands from accidental bulb breakage.
To keep your smoothtop looking like new, Amana recommends routine cleaning. Thegeneral instructions for routine and tough spot cleaning are based on the performance of Amana recommended products. To order these products, contact the Consumer Affairs department at
PART | GENERAL DIRECTIONS |
Broil element
Do not clean broil element. Any soil will burn off when element is heated.
Broiler pan and grid
Drain fat, cool pan and grid slightly. (Do not stand soiled pan and grid in oven to cool.) Sprinkle with soap. Fill the pan with warm water. Let pan and grid stand for a few minutes
Control knobs
Pull off knobs. Wash gently with mild soap and water but do not soak. Dry and return knobs to oven, making sure to match flat area on the knob to the flat area on the shaft.
Outside finish
Wash all glass with cloth dampened in soapy water. Rinse and polish with a dry cloth. If knobs are removed, do not allow water to run down inside surface while cleaning.
Oven racks
For heavy soil, place oven racks in large plastic bag with ammonia and water in cup. Seal tightly and allow to stand overnight. Wash and rinse, dry thoroughly.
Storage drawer
For heavy soil, clean by hand and rinse thoroughly. Remove drawer for ease in cleaning. Be sure drawer is dry before replacing.
26