Amana Coil Maintenance, Oven Door, Oven Window, To protect the oven door window

BULB COVER

Maintenance

Oven Door

CAUTION

•Do not place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.

•Do not attempt to open or close door or operate oven until door is properly replaced.

•Never place fingers between hinge and front oven frame. Hinge arms are spring mounted. If accidentally hit, the hinge will slam shut against oven frame and could injure your fingers.

To remove:

1. When cool, open the oven door to the first stop position (opened about four inches).

2. Grasp door at each side. Do not use the door handle to lift door.

3. Lift up evenly until door clears hinge arms.

To replace:

1.Grasp door at each side.

2.Align slots in the door with the hinge arms on the range.

3.Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.

Note: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.

Oven Window

To protect the oven door window:

1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleansers as they may scratch the glass.

2.Do not hit the glass with pots, pans, furniture, toys, or other objects.

3.Do not close the oven door until the oven racks are in place.

Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.

Oven Light

CAUTION

•Disconnect power to range before replacing light bulb.

•Use a dry potholder to prevent possible harm to hands when replacing bulb.

•Be sure bulb is cool before touching.

•Do not touch hot bulb with a damp cloth as this may cause the bulb to break.

To Replace Oven Light Bulb:

1.When oven is cool, hold bulb cover in place, then slide wire retainer off cover. NOTE: Bulb cover will fall if not held in place

while removing wire retainer.

2. Remove bulb cover and light bulb.

3. Replace with a 40-watt ap- pliance bulb.

WIRE

4. Replace bulb cover and se-RETAINER cure with wire retainer.

5. Reconnect power to range. Reset clock.

19