5.Carefully pull out blower unit. Wires extend far enough to allow blower adjustments.
6.Roll blower unit so blades face towards front of microwave oven. Wires should be routed in front of motor frame.
7.Guide wires into duct while placing blower unit back into opening.
Caution
To avoid product failure, do not pull, stretch, or pinch blower wiring.
8.Replace blower plate using 5 screws.
9.Remove 2 screws on front of grille. Remove grille.
10.Install charcoal filter. (Contact dealer to purchase charcoal filter kit).
11.Replace grille and 2 screws.
12.Proceed to "Preparing Top Cabinet".
C. Preparing Top Cabinet
1.Read instructions on top cabinet template.
2.Tape template underneath top cabinet.
3.Drill holes, following instructions on template.
D. Mounting Bracket Assembly to Wall
Microwave oven needs to be mounted against and supported by flat, vertical wall. Wall construction should be minimum of 2 inch x 4 inch wall studding and 3/8 inch or more, thick drywall or plaster/lath. Microwave oven must be attached to minimum of one 2 inch x 4 inch wall stud.
6
