Operation
Interrupting Operation
•Open oven door or press RESET pad to interrupt operation. Oven fan continues to operate. Display continues to show countdown time. Close door and press START pad to resume oven operation.
Canceling Mistakes
•If oven is not operating, press RESET pad to clear display.
•If oven is operating, press RESET pad once to stop oven, then again to clear display.
•If oven door is open and time shows in display, close oven door and press RESET pad to clear display.
Microwave Utensils |
|
|
Recommended |
| Not Recommended |
| ||
Glass/ceramic |
| Aluminum foil |
Natural fiber cloth |
| Grocery bags |
| Recycled paper | |
Plastic |
| Lead crystal, |
Wood |
| Newspapers |
|
| Metal, |
|
| Metallic trimmed china |
Utensil Check Test
Use the following test to check utensils for microwave safeness.
1.Place glass measuring cup of water next to empty dish to be tested in microwave oven.
2.Heat for one minute.
3.Check temperature of dish and water.
•If dish remains cool and water is hot, dish is microwave safe.
•If dish is slightly warm, use for short term cooking only.
•If dish is hot and water is cool, do not use. Dish remains cool if not absorbing microwaves and microwaves are being absorbed by water. Dish becomes hot if absorbing microwaves.
Operating Preprogrammed Pads
Equipment has 2 menus with 10 preprogrammed number pads. Instructions are written for factory programmed ovens. Ovens that are reprogrammed can respond differently than described below.
1.Open oven door, place food in oven, and close oven door.
•Display shows “b” or “d” and “READY”.
•Fan and light operate.
•If pad is not pressed in 30 seconds, open and close oven door again.
2.Press MENU pad to select preprogrammed menu if necessary.
•“b” or “d” shows in display.
3.Press desired number pad.
•Oven operates and time counts down.
•Display shows “POWER” only when microwave energy is present.
•If power level less than 100 percent power was programmed, display shows “COOK LEVEL” and power level. Display counts down cooking time.
•If additional heating time is required, press preprogrammed pads before or after heating cycle ends.
4.Oven stops heating and oven signal sounds when heating timing elapses.
Preprogrammed Times and Cook Level
All preprogrammed pads arrive set at full power.
Pads | Heating Times |
1 | 10 seconds |
2 | 20 seconds |
3 | 30 seconds |
4 | 45 seconds |
5 | 1 minute |
6 | 1 minute 30 seconds |
7 | 2 minutes |
8 | 3 minutes |
9 | 4 minutes |
0 | 5 minutes |
8