Amana W10175445A owner manual How to Remove and Replace Light Bulbs, How to Get the $ Most Out of

How to Remove and Replace Light Bulbs

!WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing light bulb. After replacing light bulb, connect power.

!CAUTION

To avoid personal injury or property damage, observe the following:

•Allow light bulb to cool.

•Wear gloves when replacing light bulb.

Fresh food section

1. Remove screw from light shield. Retain for replacement.

1. Slide shield toward back of compartment to release from light assembly.

2. Remove light bulbs.

3. Replace with appliance bulbs no greater than

40 watts.

4. Replace light bulb cover by inserting tabs on light shield into liner holes on each side of light assembly. Slide shield toward front of unit until it locks into place. DO NOT force shield beyond locking point. Doing so may damage light shield.

5. Replace screw removed in step 1.

Freezer section $

1. Pinch rear tabs (A) on light cover and pull straight out.

2. Remove light bulb.

3. Replace bulb with appliance bulb no greater than 40 watts.

4. Insert top tabs (B) of light cover into refrigerator liner and snap back portion over light assembly.

%

Hints and Care

How to Get the $ Most Out of

Your Energy Dollar

•When placing refrigerator into final position, allow for 1" clearance around the top and sides of unit to supply ample ventilation for optimum energy efficiency.

•Avoid overcrowding refrigerator shelves. This reduces effectivity of air circulation around food and causes refrigerator to run longer.

•Avoid adding too much warm food to unit at one time. This overloads compartments and slows rate of cooling.

•Do not use aluminum foil, wax paper, or paper toweling as shelf liners. This decreases air flow and causes unit to run less efficiently.

•A freezer that is 2/3 full runs most efficiently.

•Locate refrigerator in coolest part of room. Avoid areas of direct sunlight, or near heating ducts, registers, or other heat producing appliances. If this is not possible, isolate exterior by using a section of cabinet or an added layer of insulation.

•Refer to owner's manual section on temperature controls for recommended control settings

•Clean door gaskets every three months according to Owner's Manual cleaning instructions. This will assure that door seals properly and unit runs efficiently.

•Take time to organize items in refrigerator to reduce time that door is open.

•Be sure your doors are closing securely by leveling unit as instructed in your Owner's Manual.

•Clean condenser coils of as indicated in the owner's manual every 3 months. This will increase energy efficiency and cooling performance.

15