3-wire connection: Direct wire
Use this method only if local codes permit connecting ground conductor to neutral supply wire.
1.Loosen (do not remove) the hex washer head screws and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector.
| D |
C |
|
| E |
| F |
B | G |
| |
A |
|
A. Line 1 | E. Neutral (white) wire |
B. | F. Line 2 |
C. Hex washer head screw | G. UL listed strain relief |
D. | and power supply |
block screw | cable |
2.Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps.
B
A
A.Insert wire under screw clamp.
B.Hex washer head screw
3.Securely tighten the hex washer head screws to
35
4.Tighten the locking ring of the conduit connector.
5.Replace the terminal block cover.
Verify Anti-Tip Bracket Location
1.On models with a storage drawer, pull drawer open to first stop position. Lift front of drawer to clear white wheels in drawer guides. Remove drawer and set it aside on a covered surface.
On models with a warming drawer, the rear leg cannot be seen by removing the warming drawer. It will be necessary to view the rear foot from outside the range.
2.To check that the
■Look for the
■Slide range back so rear range foot is under
Level Range
1.Place rack in oven.
2.Place level on rack and check levelness of range, first side to side; then front to back.
3.If range is not level, pull range forward until rear leveling leg is removed from the
On Ranges Equipped with Storage Drawers:
Use a ¼" drive ratchet, wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in
On Ranges Equipped with Warming Drawers:
Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in
NOTE: Range must be level for satisfactory baking performance.
4.Replace the storage drawer (or warming drawer on some models).
9