-25-
To change factory default settings, type “set xxx (parameter) xxxx (value). For example,
set channel 7 command will set the channel to number 7; set essid “Your Network”
command will set the ESSID as Your Network. Remember that, a 'save' command is
required for changes to take effect. Always reset your AP with the “Reset” command.
The following is a list of parameters you can make changes on the unit.
Parameter Description Default Value
apname A textual name for the identification of the
WL1100B-AR Wireless LAN Access Router. apXXXXXX
(where XXXXXX is the
last six octets of
WL1100B-AR Wireless
LAN Access Router’s
MAC address)
channel The radio channel number. 1
essid The ESS ID (a.k.a., SSID) of the WL1100B-AR
Wireless LAN Access Router. My Network
rts_threshold The threshold (number of bytes) for enabling
RTS/CTS handshake. Data with its frame size
larger than this value will perform the RTS/CTS
handshake. Range of value: 0~2432.
2432
frag_threshold
The threshold (number of bytes) for the
fragmentation boundary. Data will be transmitted
in fragments which its size does not exceed this
value. Range of value: 256~2432.
2432
ip_address The IP address of the WL1100B-AR Wireless LAN
Access Router. 192.168.1.1
ip_netmask The subnet mask address of the WL1100B-AR
Wireless LAN Access Router. 255.255.255.0
ip_gateway The default gateway address of the WL1100B-AR
Wireless LAN Access Router. 192.168.1.254