AMC iM05 manual

1.XLR INPUT: This jack accepts XLR input connections with either balanced or unbalanced wiring. The input wiring of an XLR connector should be as follows:

￿XLR PIN 1 Signal ground (Shield)

￿XLR PIN 2 Signal positive (+)

￿XLR PIN 3 Signal negative (-)

2.TRS INPUT: This jack accepts 1/4" connections with either balanced or unbalanced wiring. For balanced wiring, a three-conductor TRS plug is necessary. The input wiring of a TRS connector should be as follows:

￿TRS TIP Signal positive (+)

￿TRS RING Signal negative (-)

￿TRS SLEEVE Signal ground (Shield)

Unbalanced 1/4" wiring can be done with either a two- or three-conductor (TS or TRS) plug. A two-conductor (TS) plug automatically grounds the signal negative input, whereas a three- conductor (TRS) plug, wired unbalanced, provides the option of leaving the negative input open or grounded. We recommend that you ground the unused negative input (this can be done by wiring the ring and sleeve of the TRS plug together).

The TRS input is summed through a balanced input amplifier with the XLR input, allowing both inputs to be used simultaneously. Input specifications apply to both.

3.PRODUCT SPECIFICATION: This label contains the model and specification information.

4.SUB-FREQUENCY PORT: This port aids in reproduction of very low frequencies by discharging frequencies below 60 Hz.

5.VOLUME CONTROL: Use the volume control to set the output sound pressure from the iM05 to proper levels as required.

6.POWER RECEPTACLE: Accepts a detachable 3-circuit line cord in order to power the monitor.

7.FUSE HOLDER: Holds the external main fuse.

8.VOLTAGE-SELECT SWITCH: Provides two selections - 115VAC and 230VAC, and should be set to match the "house supply" (receptacle) voltage of the country or location in which the speaker is used. The 115V setting is correct for the USA, while 230V setting is correct for most of the UK and Europe.

9.POWER SWITCH: This switch turns the monitor on and off.

6