AMD PPC-L106T 3.2 Features

Chapter 3 System Setup 25

3.2 Features

• Ultra-compact size single board computer as small as a 3 1/2" hard

disk drive (145 mm x 102 mm)

• On-board AMD LX800 CPU

• Up to 1024 MB system memory via an SODIMM (DDR)

• On-board VGA/LCD controller

• On-board 10/100Base-T Ethernet interface (dual LAN Optional)

• Supports on-board CompactFlash™ socket

• Built-in Enhanced IDE (AT bus) hard disk drive interface

• Four serial ports: three RS-232, one RS-232/422/485 or infared select-

able

• Supports One Mini PCI socket

• Supports 4 USB 2.0 (2 external, 2 internal)

• Supports 8 bit GPIO

Contents

Main Page Page Packing List Additi onal Inf ormation and Assi stance Page Page Contents Chapter 1 General Information........................................ 2 Chapter 2 System Setup...................................................14 Chapter 3 The Engine of the PPC-L106T (PCM-9679)24 Chapter A I/O Pin Assignments.......................................42 General Information Chapter 1 General Information 1.1 Introduction 1.2 Specifications Page Page 1.3 LCD Specifications * The VR control is defined by hot key in DOS or BIOS mode as follows: Ctrl-Alt-F3, Ctrl-Alt-F4 Page 1.5 I/O Arrangement Page 1.7 Mounting 1.7.1 Panel mounting Page 1.7.3 Wall-mounting (optional) Page System Setup Chapter 2 System Setup 2.1 General 2.2 Preparing For First Time Use Page 2.3.2 Installing a primary 2.5" HDD (internal) 2.4 Installing I/O Equipment 2.4.1 PS/2 keyboard and PS/2 mouse 2.4.2 Mic-in, line-out 2.4.3 External VGA 2.4.4 Four serial COM ports 2.5 Installing Software to the HDD Page 2.7 PCM-9679 and I/O Adapter Replacement Page Page Page Chapter 3 The Engine of the PPC-L106T (PCM-9679) 3.1 Introduction 3.2 Features 3.3 Jumpers and Connectors 3.3.1 Setting jumpers 3.3.2 Jumpers The table below lists the function of each of the boards jumpers. The table below lists the function of each of the board's connectors. 3.3.3 Connectors Table 3.1: Jumpers and their functions Figure 3.1: Jumpers on the PPC-L106T motherboard Figure 3.2: Connectors on the PPC-L106T motherboard J2 J3 J4 SLOT1 3.4 CMOS Clear for External RTC (J3) 3.5 COM Port Interface (J6, J7) 3.5.1 COM2 RS-232/422/485 setting (J6) Page 3.5.2 COM3/COM4 pin 9 output setting (J7) Page Page Chapter A I/O Pin Assignments A.1 Keyboard connector (CN5-1) A.2 Mouse connector (CN5-2) Table A.1: Keyboard connector A.3 VGA connector (CN6) A.4 COM1 RS-232 serial port (CN1-2) Table A.3: VGA connector Table A.4: COM1 RS-232 serial port A.5 COM3 RS-232 serial port connector (CN2-1) A.6 COM4 RS-232 serial port connector (CN2-2) Table A.5: COM3 RS-232 serial port Table A.6: COM4 RS-232 serial port A.7 COM2 Connector Table A.7: COM2 A.8 Parallel port connector (CN1-1) * active low Table A.8: Parallel port connector A.9 GPIO Connector (Default: No Load) A.10 USB 3 / USB 4 Connector (Internal) Table A.9: CN7 GPIO Table A.10: CN12 Internal USB 3 / USB 4 A.11 SMBUS Connector (Default :No Load) Table A.11: CN5 SMBUS Input