American Audio American Audio CD/MP3 Player, MCD-110

12. SEARCH BUTTONS -

This search button allows you to quickly

scan backwards through a track.

This search button allows you to quickly

scan forwards through a track.

13. TRACK BUTTONS -

This button is used to select a track.

Tapping this button will back-skip to the previous

track, holding down this button will rapidly back-

skip through the tracks on a CD.

This button is used to select your

desired track. Tapping this button will forward

skip to the next track, holding down this button

will rapidly forward skip through the tracks on

your CD.

14. RELOOP BUTTON - If a LOOP has been

made (see setting a LOOP on page 17), but the

CD Player is not actively in LOOP mode (a loop is

not playing), pressing the RELOOP BUTTON will

instantly reactivate the LOOP. To exit loop, press

the OUT BUTTON (15). LOOP and RELOOP

will appear in the LCD DISPLAY (4) when the

RELOOP function is available.

15. LOOP OUT BUTTON - This button is used to

set the ending point of a loop. A loop is started

by pressing the IN BUTTON (3), pressing the OUT

BUTTON set the loop ending point. The loop

will continue to play until the OUT BUTTON is

pressed once again.

16. PLAY/PAUSE BUTTON - Each press of the

PLAY/PAUSE Button causes the operation to

change from play to pause or from pause to play.

While in play mode the green play LED will glow,

and while in pause mode the green play LED will

flash.

17. CUE - Pressing the CUE button during play-

back immediately pauses playback and returns

the track to the last set cue point (see setting a

CUE POINT, page 18).

18. OPEN/CLOSE (TRANSPORT TRAY OPEN/

CLOSE) - This button is used to open and close

the transport tray. NOTE: The TRANSPORT TRAY

(1) will not open when a CD is already inserted,

unless the drive mechanism is in “Pause” or

“Cue” mode to prevent accidentally stopping the

music during playback.

19. POWER SWITCH - This switch is used to

control the unit's main power.

20. AUDIO OUT R & L - These jacks are used

to send a left and right output signal. Use these

jacks to send an audio signal to a mixer or

receiver. The red colored jack represents the right

channel output and white jack represents the

left channels output. Used together these signal

reproduce a stereo signal.

21. DIGITAL OUT - This jack sends a digital

stereo out signal. Use this connection to create

near perfect copies of your disc to a Mini disc,

CD-R, or any other recording device with a digital

input.

22. VOLTAGE SELECTOR - Because power

supplies vary from location to location a voltage

selector switch has been incorporated in the unit's

design. This switch can select a voltage input of

115v or 230v to accommodate the two major

power source. Always be sure to disconnect the

power plug before changing the voltage.

*Only dual voltage units have this switch.

23. POWER CONNECTION - This is the main

power connection. Only use the supplied polar-

ized power cord. Use of any power cord may

result in sever damage to the unit. Be sure the

local power source matches the units’ required

power.

24. TIME BAR INDICATOR - This bar visually

details the time defined in the TIME METER (29,

30, & 31). As with the TIME METER (29, 30, & 31),

this bar is also dependent on the selected time

function REMAIN OR TOTAL. This bar will begin

to flash when 15 seconds of a track remain and

will begin to rapidly flash when three seconds of

a track remain. The flashing bar is a great visual

reminder a track is about to end. The flashing bar

will function regardless of which time mode the

unit is in.

25. SINGLE INDICATOR - This indicates the unit

is in single play mode, the unit will play a single

track and return to CUE mode. If the SINGLE

FUNCTIONS AND CONTROLS