©American Audio® - www.americanaudio.us - VMS4™ Instruction Manual Page 13
FrONT PANEL - gENErAL FUNCTIONS AND CONTrOLS
FRONT PANEL -
mic Section (21-23) - the vmS4 is equipped with 2 microphone inputs, easy to use, no aSio rout-
ing required. each microphone channel has an independent on/off switch, gain control, and 3 band
eq.
21. MIC ON/OFF - Turns the corresponding microphone on/off. When you Mic is on the button will
be backlit by a red LED.
22. MIC gAIN CONTROL - Increase or decrease the microphone output.
23. MIC EQ - Adjust the treble, mid, and bass on the corresponding Mic inputs.
miXer controlS (24-25) - the vmS4 can be used as a midi control, a stand alone mixer, or com-
bination giving you maximum control of your music collection whether it be on vinyl, digital cd's or
computer dJ software (virtual dJ included).
24. USB/ANALOg SWITCh - These will switch the corresponding Channel from USB audio stream
or analog audio input. USB will route the software assigned ASIO audio channel thru the corre-
sponding MIDILOG™ channel. Analog will route the analog audio input from the rear panel thru the
corresponding MIDILOG™ channel.
25. CF ASSIgN A & B - CF Assign A will select the desired channel to the left side of the crossfad-
er.* CF Assign B will select the desired channel to the right side of the crossfader.*
* Normal Mode: This will be the opposite when the crossfader is reversed.
* The CROSSFADER will only effect a channel's volume when the channel is assigned.
interface mode (26-28) - the vmS4 can be used as a midi control, a stand alone mixer, or combi-
nation giving you maximum control of your music collection whether it be on vinyl, digital cd's or
computer dJ software (virtual dJ included).
26. 4 OUT: 4 OUT X 4 IN USB - Sets MIDILOG™ channels 2 & 3 to receive audio from software
with ASIO outputs and sends audio or control tones from the channel 2 & 3 RCA inputs to your
software ASIO inputs.
8 OUT: 8 OUT X 2 IN USB - Sets 4 MIDILOG™ channels to receive audio from software with
ASIO outputs and sends the audio from the master output via USB for recording.
27. NORMAL/REVERSE - Switches the crossfader from normal to reverse mode. In reverse mode
the CF A assignments will be on the right of the crossfader and the CF B on the left.
28. CURVE KNOB - This knob will adjust the curve of the crossfader from mix curve, dipped curve,
to scratch curve.
21 22 23 24
25
24
26
24 24 27 29
25
30 31
28