©American Audio® - www.americanaudio.us - VMS4™ Instruction Manual Page 15
rEAr PANEL - gENErAL FUNCTIONS AND CONTrOLS32
34 35
33 33 36 37 38
41 41
4039 39 40 39 39 42 43
REAR PANEL -
32. POWER SWITCh - This switch will tur n the VMS4 on/off.
Attention: Make sure that nothing is touch or resting on the jog wheels when you power on the
VMS4.
outputS (33-38)
33. Q-START - These 1/8 jacks remotely start playback in Q-Start equipped or compatiable CD
players. The start and stop correspond to the audio start and stop of the corresponding side of the
crossfader.
34. POWER SUPPLY - The power supply is not required, but the LED indicators on the mixer knobs
will be dim, headphones may be underpowered, and there is an increased chance of audio distor-
tion.
35. USB PORT - Connect to your PC for MIDI interface and USB interface (audio in and outs).
36. XLR BALANCED OUTPUTS - The VMS4 has RCA (unbalanced) and XLR (balanced) connec-
tions to connect to amplifiers or connect directly to powered speakers. It is highly recommended
that the XLR outs be used for any connection of more then 20ft. Never connect the XLR outs and
the RCA outs at the same time, this may affect your output. To set your desired volume use the
Master volume knob.
37. BOOTh OUTPUTS - The VMS4 offers a secondary output usually used to monitor your mix
or to route to an outboard recording device. This output has independent volume control "Booth"
knob.
38. RCA OUTPUTS - The VMS4 has RCA (unbalanced) and XLR (balanced) connections to connect
to amplifiers or connect directly to powered speakers. It is highly recommended that the XLR outs
be used for any connection of more then 20ft. Never connect the XLR outs and the RCA outs at the
same time, this may affect your output. To set your desired volume use the Master volume knob.
inputS (39, 42-43)
39. RCA INPUTS - RCA connectors for CD, turntable, and other analog inputs.
MIDILOG™ 1: Line level RCA input use to control CD players, Mp3 players, or other line level
sources.
MIDILOG™ 2: Phono/line level RCA input use to connect turntables, CD players, Mp3 play-
ers, or other line level sources. The type of input must directly reect the selected mode of
the line/phono Selector Switch. Turntables equipped with MM pickup cartridge (All
DJ turntable use MM pick-up cartridges) may be connected to these jacks as long as the
line/phono Selector Switch is in the “PHONO” position. CD players, Mp3 players,