American Audio WM-UHF16 Connecting the Receiver Output, WM UHF16 SYSTEM SET UP Cont., WM UHF16 TROUBLE SHOOTING

©American Audio® - www.americanaudio.com - WM UHF16™ Instruction Manual Page 7

WM UHF16 ™ OPERATIONOperating Instructions

1. Select the channel frequency, make sure the receiver and transmitter are set to the same

channel.

2. Switch the receiver and transmitter power button to the “ON” position. If the signal from the

transmitter is being received by the receiver the AF LED should light up.

Note: Make sure the volume on the receiver is turned all the way down before switching on

the power.

3. Speak, sing, or play your instrument at a typical level. The RF LED should ﬂicker when receiving a

signal from the transmitter.

4. When ﬁnished, slide the power to the OFF position on the transmitter. Then turn the power switch

to the OFF position on the receiver.

Connecting the Receiver Output

1. You can connect the receiver to a output source using a cable with an 1/4’’ jack or 3-pin XLR

female connection.

2. Connect one end of the cable to the receiver, and the other end into the mic input of a mixer, PA

system, or ampliﬁer.

WM UHF16 ™ SYSTEM SET UP Cont. WM UHF16 ™ TROUBLE SHOOTING

Trouble Shooting: Listed below are common problems you may encounter, and their solutions.

There is no power to the unit:

1. Make sure you have connected the power cord to a 120v wall outlet.

There is little or no sound:

1. Make sure the battery is inserted properly (+/- battery terminals must match transmitter termi

nals).

2. Make sure that the transmitter power switch is not set to mute.

3. Move transmitter closer to the receiver.

4. Is the low battery LED lit? If so replace the battery.

5. Make sure the receiver volume is not turned all the way down.

6. Check the cable connection between receiver and ampliﬁer or mixer.

There is a momentary loss of sound when the transmitter is moved around the area:

1. Move the receiver around a perform walk-through tests. If audio dropouts continue, mark the

“dead” areas and avoid the during performance.

Radio signals are interrupting performance:

1. Change the frequency channels on both the transmitter and receiver.