American Audio XDM-3633 manual 35b, Inputs and Outputs Rear Panel

Inputs and Outputs (Rear Panel)

35b 42 41 35a

GND

115V

AC INPUT								GND
115/230V
					LIGHT CONTROL	AUX 3	3 AUX 2 PHONO 2	AUX 1 PHONO 1
	RIGHT	LEFT	RECEIVE SEND
AC VOLTAGE				ZONE 2 ZONE 1 REC	MASTER LINE 6 LINE 5	LINE 4 LINE 3 PHONO 3	LINE 2 PHONO 2 LINE 1 PHONO 1
						AUX 3	AUX 2	AUX 1 MIC 3
SELECTOR
								L
								R
FUSE	BALANCED OUTPUT		EFFECT	OUTPUT	-4	CH-3	CH-2	CH-1

50 49 48 47 46 45 44 43 40 39 38 37 38

(35a) (35b) GND (GROUND TERMINALS) - Connect the ground lead of the turntables with this terminal. This helps to reduce humming and popping noises. There are two convenient ground terminals located on the rear of the mixer.

(36)MIC 3 JACK - Connect your third microphone with 1/4 inch (6.3mm) jack plug here. To use MIC 3, CH-4 LINE 5/ LINE 6/MIC 3 SWITCH (3) must be switched to MIC 3. To turn MIC 3 OFF, change the LINE 5/LINE 6/MIC 3 SWITCH to LINE 5 or LINE 6.

(37), (38), (39), (40) LINE / PHONO / AUX INPUT JACKS - Input jack for CH-1, CH-2, CH-3 and CH-4. Connect turnta- bles equipped with MM pickup cartridge to PHONO inputs. CD players or Tape Decks should be connected to LINE input. Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers should also be connect- ed to LINE inputs. CHANNEL 1 (37) features left and right RCA inputs for LINE 1 and PHONO 1 / AUX 1. CHANNEL 2

(38)features left and right RCA inputs for LINE 2 and PHONO 2 / AUX 2. CHANNEL 3 (39) features left and right RCA inputs for LINE 3, LINE 4 and PHONO 3 / AUX 3. CHANNEL 4 (40) features left and right RCA inputs for LINE 5 and LINE 6.Other inputs (ie. CD players) may also be used in the PHONO/AUX RCA jacks(37, 38, 39) when the PHONO/AUX SELECTOR SWITCH (41) is set to AUX.

(41)PHONO / AUX SELECTOR SWITCH - Changes phono to an extra line; allows the DJ to use a CD player or other input device in the same line as the phono line. When using a turntable select PHONO, and when using other input devices select AUX. PHONO/AUX lines can be used with LINES 1, 2, and 3. The PHONO /AUX SELECTOR SWITCH gives the DJ the possibilities of 3 extra inputs lines (ie. 3 lines CD, tape etc.).

(42)INDEPENDENT LIGHT CONTROL - Buffered audio output for light controllers that can use external input. Great for Touch Panels and Chase Controllers.

(43)MASTER OUT - Parallel output of P.A. output. Connect with the input of a power amplifier. Make sure that the STEREO/MONO switch (32) is set to STEREO.

(44)REC OUT - Connect to your record unit. The REC OUT level is not influenced by the MASTER FADER (31).

(45)ZONE 1 & ZONE 2 OUTPUTS - Left & Right RCA output jacks controlled by the ZONE 1 & ZONE 2 (24, 25, 26) controls on the front panel.

(46)SEND & RECEIVE EFFECTS - Left & Right 1/4” stereo jacks for SEND (27) & RECEIVE (28) EFFECTS.

(47)BALANCED OUTPUT - Balanced output for the master signal.

(48)AC CONNECTION - Standard IEC plug with detachable AC power cord.

(49)FUSE - Fuse holder. Only replace the fuse when the device is disconnected from main power supply. Only replace with fuses of the same power rating.

(50)AC VOLTAGE SELECTOR - Select between 115V/50Hz or 230V/60Hz. Make sure that the selector is set to the proper voltage you are using.

XDM-3633 User Instructions page 7