©American Audio® - www.AmericanAudio.us - XSP-A Series - Instruction Manual Page 7
XSP-A Series Controls and Features
1. BALANCED XLR LINE INPUT – This connection is designed to accept a balanced line input
signal from a mixer or other line level device with a balanced output jack. Use a balanced
cable when the signal cable length exceeds 15 feet, this will reduce excessive signal loss. Be
sure to connect only line level input devices such as mixers and tape machines to this jack.
2. MIC XLR INPUT - Plug a mic directly into this port for public address usage and let your
voice be heard. (No phantom power)
3. MICROPHONE/LINE INPUT VOLUME – This knob is used to increase or decrease the vol-
ume ouput on your XSP-8A.
4. POWER INDICATOR LED - LED lights up to indicate the speaker is on.
5. CLIP LED - If this LED is lit it means your signal is clipping. To stop the signal from clipping
lower the volume to the point where the LED is blinking along with the bass beat.
6. AC VOLTAGE SELECTOR - This switch is used to change the operating voltage. Operat-
ing voltage can be toggled between 115v or 230v/50~60Hz. Be sure the selector is set to
the proper voltage for your area before attempting to operate the unit. Always be sure
main power is shut off before change the position of the Voltage Selector Switch.
7. MAIN POWER SWITCH – This is the main power ON/OFF button. A green LED directly above
the power switch will glow indicating power is ON. Before main power is applied, be sure you
have made all connections to the speaker. Remember to avoid damaging pops to the speak-
ers, the mixer is turned on rst and turned off last. Always turn down the INPUT VOLUME (3)
before switching off the speaker. Never turn off the speaker when there is a running sig-
nal!
Rear of XSP-8A
LEVEL
110V 220V
MIC
INPUT
200 WATTS
LINE IN
LINE OUT
1
2
3
7
6
5
4
9
8
10