Introduction: Thank you for purchasing the Crusader™ by American DJ®. For your convenience the Crusader™ has been lamped and is ready for use, there is no assembly necessary. The Crusader™ may be hung or set on a flat surface. The Crusader™ comes with a
Operating Instructions: This unit comes with a
Lamp and Fuse Replacement:
Caution! To avoid the risk of electrical shock or injury never attempt to open up the unit while it is in use. Always disconnect the main power before attempting to replace the lamp or fuse. Remember to always replace with the exact same type lamp and fuse unless otherwise instructed to do so by an authorized American DJ® service technician.
Lamp Replacement: Remove the two thumb screws that are located on the front cover of the unit to expose the lamp. When the cover has been removed gently pull out the old lamp and remove it from the socket assembly. Replace with a new lamp being sure to only touch the outside of the reflector. Carefully insert the socket assembly back into the unit. Replace the cover and screw in the thumb screw.
Warranty: The American DJ® Crusader comes with a 90 day limited warranty. We recommend filling out the warranty registration card that came with your fixture to validate your warranty. For service please contact your American DJ® dealer.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried out periodically to optimize light output.
1.Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2.Use a brush to wipe down the fan grill.
3.Clean the external optics with glass cleaner and a soft cloth every 20 days.
4.Clean the internal optics with glass cleaner and a soft cloth every
5.Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (I.e. smoke, fog residue, dust, dew).
Trouble Shooting:
Listed below are a few common problems the you may encounter, with solutions.
No light output from the unit;
1.Be sure you have connected your unit into a standard 110V wall outlet.
2.Be sure the external fuse has not blown. The fuse located on the back panel.
3.Remove the lamp cover and be sure the lamp is seated in its socket properly. Occasionally lamps become loose during shipping be sure the lamp is push in to its socket all the way.
Unit does not respond to sound;
1.Be sure the unit's mode switch is in the "I" position, this is the only mode that allows the unit to operate in sound active mode.
2.Low frequencies (bass) should cause the unit to react to sound. Tapping on the microphone, quiet or high pitched sounds may not activate the unit.
© American DJ® Los Angeles, CA 90058 - Crusader User Manual page 2