American DJ S-10S operating instructions Operating Instructions, Introduction

American DJ® User Instructions

S-10S™

Single Channel Strobe Controller

Thank you for purchasing this American DJ® product. For your con- venience this strobe controller has been tested and is ready to be used, there is no assembly required. Please read and understand the fol- lowing instructions completely before attempting installation or using your new unit.

Caution! This apparatus must be grounded. To prevent fire or electri- cal shock, do not expose this appara- tus under a high temperature or humid area. There are no user ser- viceable parts inside please do not attempt any type of service or repairs.

For all service issues please refer to your authorized local American DJ dealer

Operating Instructions:

1.Be sure the input power matches that of your unit and plug your unit in.

2.Turn the power switch to on position.

3.Select your desire control mode (Flash/Stand-By/Audio)

Flash Mode will allow you to manually adjust the rate of the flash by turning the rate knob in either a clockwise or counter-clockwise position (Clockwise will increase the flash rate and counterclockwise will decrease the flash rate.

Stand-By mode is basically a black out mode in this setting the strobe will not flash at all.

Audio mode will flash the strobe according to beat detected by the controllers built-in microphone.

Introduction:

The S-10S™ is a single channel strobe controller. It features three operating condi- tions; Stand By (black out), Flash button, (manual), and Audio (sound active). This con- troller also features a Variable Speed Control Knob. The S-10S™ will control up to 6 American DJ® Super Strobe™, S150™, S- 100A™, and SNAPSHOT™strobes with 1/4” mono cable.

Model: S-10S™

SPECIFICATIONS:

Power:	110V-130V/60Hz
Weight:	2 lbs.
Size:	6” x 2.5” x 2”
	Sound Active

©American DJ Supply® - Los Angeles, Ca. 90058 - www.americandj.com - S-10S™