![](/images/new-backgrounds/1304551/3045517x1.webp)
Trance Wheel™ | Operation |
Power Supply: Before plugging your unit in, be sure the source voltage in your area matches the required voltage for your American DJ® Trance Wheel™ before attempting operation.
General Operation: Just plug this light in, and watch it go. This fixture is designed to operate as a stand alone unit. It has been tested and the lamp has been installed at the factory there is no assembly necessary. The Trance Wheel™ is ready to be plugged in, out of the box. There is no power switch, after plugging the unit the unit’s internal beveled glass wheel will rotate continuously in a single direction, while the outside color dish will rotate back and forth to the beat of music. The unit will create
Operating Modes:
This unit comes with a
Switch in the "I" position: Mode 1 - In this mode the internal oil wheel and the external
Switch in the “0” position: Mode 2 - In this mode the internal oil wheel will continuously rotate while the external
Switch in the “II” position: Mode 3 - In the this mode the internal oil wheel will continuously rotate in one direction while the outer multi- mirror dish will react to sound. Please note that tapping on the unit, or high pitched sounds may not trigger the unit, the unit is designed to react to low frequencies (bass). Also note that the music sensitivity is preset at the factory and may not be changed or adjusted.
Focusing:
The unit has a fully focusing lens. The lens is focused by manually turning the lens in either a clockwise or
Trance Wheel™ | Fuse & Lamp Replacement |
Caution: Always replace with the exact same type lamp and fuse, unless otherwise specified by an authorized American DJ® technician. Replace with anything other than the specified part can damage your unit and will void your manufactures warranty.
Warning: If after you have replaced the lamp or fuse and you continue to blow either one, STOP using the unit. Contact customer support for further instructions, you may have to return the unit for servicing. Continuing to use the unit may cause serious damage.
Fuse Replacement: Disconnect the unit’s main power supply. Insert a standard flat head screw driver in to the fuse holder housing (located on the rear of the unit). Turn the screwdriver in a
Lamp Replacement: Caution! Never open the unit when in use. Always disconnect the main power and allow the fixture ample time to cool before attempting to replace the lamp. Lamp replacement has been made simple by incorporating a split dome that is retained by thumb screws. Again, please remember to always replace with the exact same type lamp.
1.Be sure to follow the proper procedures when handling halogen lamps. Never touch the new lamp with your bare fingers.
2.Unscrew the single thumb screw (7) located on the bottom of the unit.
3.Once the thumb screw (7) has been remove, pull back the lamp assembly cover plate (6) to expose the lamp (4).
4.Remove and replace the lamp with an exact match.
5.Reassemble in reverse order.
4
6
7
©American DJ® - www.americandj.com - Trance Wheel™ Instruction Manual Page 7 | ©American DJ® - www.americandj.com - Trance Wheel™ Instruction Manual Page 8 |