Note
!When ordering replacement parts from the Maytag distributor or the Maytag Co. be sure to give them
the correct model number and serial number so that your parts order can be processed in an expeditious manner.
Warranty Information _________________
Warranty
For a copy of the manufacturer’s commercial warranty covering your particular dryer(s), contact the Maytag distributor from whom you purchased the equipment and request a dryer warranty form. If the distributor cannot be contacted or is unknown, warranty information can be obtained from the Maytag Co.
Note
!Whenever contacting the Maytag Co. for warranty information, be sure to have the dryer’s model
number and serial number available so that your inquiry can be handled in an expeditious manner.
Routine Maintenance _________________
Cleaning
A program and/or schedule should be established for periodic inspection, cleaning, and removal of lint from various areas of the dryer, as well as throughout the ductwork system. The frequency of cleaning can best be determined from experience at each location. Maximum operating efficiency is dependent upon proper airflow. The accumulation of lint can restrict this airflow. If the guidelines in this section are met, the dryer will provide many years of efficient, trouble free, and most importantly, safe operation.
Warning
!Lint from most fabrics is highly combustible. The accumulation of lint can create a potential fire
hazard. Keep dryer area clear and free from combustible materials, gasoline, and other flammable vapors and liquids.
Note
!Suggested time intervals shown are for average usage which is considered 6 to 8 operational
(running) hours per day.
Important
!Dryer produces combustible lint and must be exhausted to the outdoors. Every 6 months,
inspect the exhaust ducting and remove any lint buildup.
Suggested Cleaning Schedule
Every Load
Clean the lint screen every load. A clogged lint screen will cause poor dryer performance. The lint door/drawer is located just below the loading door of the dryer. Open the lint door/ drawer, brush the lint off the lint screen, and remove the lint. Inspect lint screen and replace if torn.
Note
!To remove the lint drawer from the dryer, pull drawer out approximately halfway. Next remove
the two retainer clips located on the sides of the lint drawer.
Important
!The frequency of cleaning the lint screen can best be determined from experience at each location.
Weekly
Clean lint accumulation from lint chamber, thermostat, and microprocessor temperature sensor area.
Warning
!To avoid the hazard of electrical shock, discontinue electrical supply to the dryer.
90 Days
Remove lint from gas valve burner area with a dusting brush or vacuum cleaner attachment.
Clean any lint accumulation in and around the motor(s) casing opening.
Note
!To prevent damage, avoid cleaning and/or touching
Every 6 Months
Inspect and remove lint accumulation in customer furnished exhaust ductwork system and from dryer’s internal exhaust ducting.
Note
!The accumulation of lint in the exhaust ductwork can create a potential fire hazard.
Do not obstruct the flow of combustion and ventilation air. Check back draft dampers in the exhaust ductwork. Inspect and remove any lint accumulation, which can cause the damper to bind or stick.
A back draft damper that is sticking partially closed can result in slow drying and shutdown of heat circuit safety switches or thermostats.
When cleaning the dryer cabinet(s), avoid using harsh abrasives. A product intended for the cleaning of appliances is recommended.
Adjustments
7 Days After Installation
and Every 12 Months Thereafter
Inspect bolts, nuts, screws, setscrews, grounding connections and nonpermanent gas connections (unions, shutoff valves, and orifices). Belts should be examined. Cracked or seriously frayed belts should be replaced. Complete an operational check of controls and valves. Complete an operational check of all safety devices (lint door/ drawer switch, door switches, sail switch, and
113413 - 11 | Maytag Co. | 19 |
