Using the AD2089 in Operate Mode
20 AD2089 Operator’s Manual
3Press the PATRN key (P-1, P-2, or P-3 appear in the ENTER display) and then press the RUN
key. The camera will sequence through the pattern movements once.
To repeat a pattern:
1Follow the procedure described immediately above to run a pattern.
2After pressing the PATRN key (P-1, P-2, or P-3 appear in the ENTER display), press the ACK
key to repeat the pattern.
To hold a pattern:
1Follow the procedure to run a pattern.
2After pressing the PATRN key , press the HOLD key to bring th e camer a or d ome to the st arti ng
point of the pattern and hold there.
Running a Macro
A macro is a sequence of keyboard inputs of up to 21 keystrokes, that is executed by typing the
macro’s numeric identifier (up to four digits), and pressing the macro’s designated key. A macro
can be made up of all Monitor mode inputs, all DVMS mode inputs, or a combination of both.
To run a macro:
1Type the macro’s numeric identifier.
2Press the macro key (the macro is executed).
Procedures and examples of macro programming are covered in the following chapter.