4.Route the new long harness along the outer edges of the enclosures following the path of the original wiring as closely as possible. Use
5.Attach the new long harness to the transponder in the CTEG4M Enclosure. See figure below for details.
Rear View CTEG4M Enclosure
Existing Wiring harness for Generator Control
Utility Meter
XP7 connector for transponder
B:Attach the wire previously cut from Pin #7, to the ground bar using a butt- splice. (Wire NOT included).
6.Verify system functionality.
A:Cut the original wire to Pin #7. Attach the new long harness wire to the plug side, using a
Transponder
Ground Bar
New long harness
•Force the engine to crank, allowing failure to start. An error message should appear at the
•Turn the generator ON.
•Turn the generator OFF.
Connect Power to the Enclosures
1.Reconnect the battery in the generator enclosure.
2.Switch the battery circuit breaker ON.
3.Switch the utility circuit breaker ON.
4