![](/images/new-backgrounds/1149474/14947421x1.webp)
3.0 Installation
3.4 Output wiring procedure - continued
3.4.4Use a 3/8" wrench to remove the protective earth wire (green with yellow stripes) ring terminal fastened at the earthing stud on the Isolation Unit.
Diagram showing power distribution plate earth connection
3.4.5Remove the desired
3.4.6Fasten an appropriately sized and approved cable clamp (not provided) onto the power distribution plate.
3.4.7Strip insulation from the output cable wire ends at the length given in Table 3.2.1.
3.4.8Threadtheoutputcablethroughthecableclampandthroughthepowerdistributionplate hole. Arrange the cable so that the end is near the output termination block.
Page 9