INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
ABOVE COUNTER SINK
FOR USE WITH: 0621.001 STUDIO
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED FAUCET*: 2064.101 ONE lavatory faucet
*Log on to
RECOMMENDED TOOLS AND MATERIALS
Putty Knife | Regular Screwdriver | Adjustable Wrench | Drill | Tape Measure |
Hacksaw | Phillips Screwdriver | Pipe Wrench | Basin Wrench | Channel Lock Pliers |
Tubing Cutter | Jig Saw | Silicone Adhesive | Plumber’s Putty or Caulking | |
OBSERVE LOCAL PLUMBING AND BUILDING CODES
1a Countertop Installation:
Using the template provided, locate the position of the sink on the countertop. Provide proper clearance under the countertop for the faucet supply lines, drain assembly and the structural parts of the cabinet. NOTE: If replacing an existing sink be certain to shut off water supply before removing old sink.
1b Mounting on Studio 22" Vanity:
Assemble vanity as per instructions.
2Drill a clearance hole inside the perimeter line of the template for countertop installation.
4a |
T U R E U S E
Perimeter |
of |
template |
Perimeter of |
template |
Countertop Installation:
•Place the sink temporarily into the template
•Check for alignment and clearance
•Mark the sink and countertop in several places as a guide for the installation location.
4b Vanity Installation:
O R F U
Cut opening around the perimeter of the template.
3Mount the faucet and drain assembly (not included) on the sink following the manufacturer’s instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part “A”) in order to ensure a watertight seal between the sink and drain. Remove excess putty after installing drain on sink.
A
•Place the sink temporarily on the vanity to check for alignment and clearance
•The sink should be centered left to right on the vanity with the front edge of the sink even with the front of the vanity
5 |
After checking fit and alignment, turn sink upside down and apply a generous portion of silicone adhesive around the under side of the rim near the edge. Place sink in position. Wipe off excess adhesive.
S A V E F
P r o d u c t n a m e s l i s t e d | h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c . | |
© A S A m e r i c a , I n c . 2 0 0 8 | ||
