5
MANIFOLD INSIDE WATERWAY -
DO NOT REMOVE
POSITION TOILET ON FLANGE
FLANGE
NUT
TAPERED
WASHER
CLOSET
BOLT
a.Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes.
b.Loosely install retainer washers and nuts. Side of washers marked "THIS SIDE UP" must face up!
6
BOLT CAP
CLOSET FLANGE |
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.
!CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Install caps on washers.
(If necessary, cut bolt height to size before installing caps.)
c.Smooth off the bead of sealant around base. Remove excess sealant.
CLOSET BOLT
WASHER NUT
7
RUBBER
TANK MTG. 
GASKET BOLTS PRE-
INSTALLED
WASHER/NUT
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washer/nuts.
b.With tank parallel to wall, alternately tighten hex nuts until tank is snugged down evenly against bowl surface.
Recommended tool: Deep socket tool included in tank kit.
!CAUTION: DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
DO NOT SPIN BOLTS WITH SCREWDRIVER
| 8 |
| INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions. |
|
|
|
|
| 9a | Before continuing, determine the type of water supply connection you have from the chart below and use the appropriate assembly parts | |
|
|
| required to properly reconnect the water supply. DO NOT use plumber's putty to seal these fittings. |
METAL/COPPER | METAL FLANGED | METAL SPIRAL | VINYL/BRAIDED | |
FLARED TUBING | TUBING | TUBING | CONNECTOR | |
LOCK NUT | LOCK NUT | LOCK NUT | LOCK NUT | |
CONE | EXISTING | EXISTING | COUPLING | |
WASHER | ||||
WASHER | CONE | NUT | ||
| ||||
COUPLING | EXISTING | WASHER |
| |
|
| |||
COUPLING | COUPLING |
| ||
NUT |
| |||
| NUT | NUT |
| |
WATER | WATER | WATER | WATER | |
These parts must be used as | Use existing | Use existing spiral | Captive cone | |
illustrated to insure | coupling nut | cone washer. | washers already | |
connection. Use of existing | and washer. | Fluidmaster cone | included. No | |
coupling nut may result in |
| washer may not | additional washers | |
water leakage. Water supply |
| seal completely on | needed. | |
tube or pipe must extend at |
| spiral type supply |
| |
least 1/2" inside threaded |
| line. |
| |
shank of valve (does not apply |
|
|
| |
to flanged tubing). |
|
|
|
CAUTION: DO NOT USE CONE WASHER WITH PLASTIC SUPPLY LINE.
CAUTION: Overtightening of LOCK NUT or COUPLING NUT could result in breakage and potential flooding.
- 3 - |
