9b
With correct washers in place (see Step 9a), tighten COUPLING NUT 1/4 turn
10
ADJUSTMENTS
TOP | ARM |
|
|
| |
| NIPPLE |
|
| REFILL |
|
| TUBE | TANK |
|
| |
|
| LEVER |
CRITICAL LEVEL |
|
|
MARK ("C.L.") |
|
|
MUST BE |
|
|
1" ABOVE |
|
|
OVERFLOW PIPE |
|
|
FLOAT |
| Fig. 10A |
CUP |
| |
FILL |
|
|
VALVE |
|
|
WATER LEVEL |
|
|
ADJUSTMENT |
|
|
CLIP | LINK |
|
VALVE | ADJUSTABLE |
|
BODY |
| |
HEIGHT |
| |
|
| |
| SHANK |
|
| WASHER |
|
LOCK NUT | THREADED |
|
| SHANK |
|
CONE WASHER |
|
|
| PARTS FOR WATER |
|
COUPLING NUT | CONNECTION |
|
(SEE STEP 9) |
| |
(HAND TIGHT ONLY) |
| |
| Diagram 1 | |
|
|
beyond hand tight.
DO NOT OVERTIGHTEN.
a.Adjust water level. Water level should be adjusted to level indicated in tank by adjusting float cup. See Step 11 for water level adjustment method.
IMPORTANT:
b.If bowl fails to siphon, an adjustment may be required with the lift chain. Simply remove the bead chain from the retainment clip (see Fig. 10A) and take up slack on the chain, and reinsert on lift rod. Make sure the chain is not too taught.
11 | Turn on water supply. | 12 | CARE AND CLEANING |
|
|
| |
| Adjust water to water |
|
|
| level specified in the tank |
| When cleaning your toilet, wash it with mild, soapy water, rinse |
| by squeezing water level |
| |
|
| thoroughly with clear water and dry with a soft cloth. | |
| adjustment clip and |
| |
|
|
| |
| moving FLOAT CUP up | ! | WARNING: Do not use |
| or down along stainless | ||
|
| seriously damage fittings in the tank. This damage can cause leakage | |
| steel link. |
| |
|
| and property damage. | |
|
|
| |
|
|
| American Standard shall not be responsible or liable for any |
|
|
| damage caused by the use of |
13 | TROUBLE SHOOTING FLUSH VALVE: | 13a | REFILL TUBE REPLACEMENT: |
SEAL REPLACEMENT:
1.Disconnect Chain.
2.Lift float up and remove flush valve seal by pulling seal out of groove and sliding up over float.
3. Reverse procedure to install new seal. | Locate bottom portion of | ||
hose clip between the ribs (2) | |||
|
| ||
|
| on bottom of funnel inlet. | |
FLOAT | FLUSH | Note: Rotate funnel to position | |
ribs at rear of the tank. | |||
VALVE | |||
| SEAL |
|
NOTE: DO NOT ADD ANY FOREIGN MATERIALS
TO THE SEALING SURFACE.
- 4 - |