American Standard 2073 installation instructions Note Back-To-Back Installation

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

Model 2073 FloWise™ Normal Height

Elongated High Efficiency Toilet

Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

NOTE: BACK-TO-BACK INSTALLATION
Depending upon your plumbing and venting conditions, the flow
from the FloWise in a back-to-back installation may create a
vacuum on the system and draw water from the opposing bowl.
The National Standards Plumbing Code prohibits the use of a
cross fitting for drainage as throw over is possible. The code does
approve a directional "Y" style fitting with proper venting to direct
the water downward and away from the other toilet.	Recommended fitting type for back-to-back installations.

RECOMMENDED TOOLS AND MATERIALS

Putty Knife	Regular Screwdriver	Adjustable Wrench	Sealant
Hacksaw	Wax Ring/Gasket	Flexible Supply Tube	1/2" Deep Well Nut Driver or
Closet Bolts	Tape Measure	Carpenters Level	Deep Well Socket Wrench

1REMOVE OLD TOILET

a.Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b.Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!

c.Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d.Remove closet bolts from flange and clean away old wax, putty, etc. from base area. NOTE: Mounting surface must be clean and level before new toilet is installed!

E F O R F U T U R E U S E

2ROUGHING-IN DIMENSIONS: Normal Height Elongated Two Piece Toilet

NOTE: DRAWINGS ARE FOR DIMENSIONAL PURPOSES ONLY. THEY ARE NOT EXACT REPRESENTATIONS.

3

S A V

FINISHED WALL

		762mm
	19mm ± 6mm	(30")
	(3/4 ± 1/4")
	222mm
	(8-3/4")
		470mm
		(18-1/2")
		C/L OF SEAT POST HOLES
		140mm (5-1/2" CENTERS)
83mm (3-1/4")		381mm
		(15")

	16mm
	(5/8")
254mm	343mm	FINISHED
(10")		FLOOR
	(13-1/2")
305mm
	C/L OF OUTLET
(12")

	438mm
	(17-1/4")
	C/L
SUPPLY	794mm
AS
REQ'D	(31-1/4")
203mm	356mm
	(14")
(8")
114mm
(4-1/2")
	267mm
	(10-1/2")

CLOSET FLANGE

A

CLOSET BOLTS

INSTALL CLOSET BOLTS

Install closet bolts in flange channel, turn 90°, and slide into place 6" (152 mm) apart and parallel to wall.

P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c . © A m e r i c a n S t a n d a r d I n c . 2 0 0 7

730924-100 Rev. E