14
LIFT ARM
FIRST
IMPORTANT: Always clear sand and rust from system. Make sure water supply is off.
Remove valve TOP by lifting arm and rotating top and arm 1/8 turn counterclockwise, pressing down slightly on cap.
TROUBLESHOOTING FILL VALVE
While holding a container over the uncapped VALVE to prevent splashing, turn water supply on and off a few times. Leave water supply off.
Replace TOP by engaging lugs and rotating 1/8 turn clockwise.
MAKE CERTAIN TIP IS TURNED TO THE LOCKED POSITION. VALVE MAY NOT TURN ON IF TOP IS NOT FULLY TURNED TO THE LOCKED POSITION.
IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 14.
IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF
•The end of the refill tube is inserted into overflow pipe, below water level in tank. Attach refill tube to overflow pipe using "S" clip provided.
•The flush valve is leaking because it's worn, dirty or misaligned (replace seal or flush valve).
IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF TANK WATER IS SLOW after valve has been in use for some time, Fluidmaster
Model 242 Replacement Seal may be needed.
For troubleshooting information please contact:
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675
(949)
www.fluidmaster.com
Manufacturer's First Year Fill Valve Warranty:
© 2001 Fluidmaster, Inc.
® Registered trademark of Fluidmaster, Inc.
GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.
Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster shall not be responsible or liable for any damages caused by products used with Fluidmaster valves that were not manufactured by Fluidmaster, Inc.
See next page for FloWise™
REPAIR PARTS LIST
Repair parts are determined by toilet tank number which can be found marked inside tank.
NOTE: "XXX" represents color or trim finish options. Specify when ordering.
PART NO. | DESCRIPTION |
TRIP LEVER | |
BOLT CAP KIT (INCL. 2 COVERS & WASHERS) | |
FLUIDMASTER 400A VALVE | |
FLUSH VALVE SEAL KIT | |
FLUSH VALVE ASSEMBLY | |
CLEVIS PIN ASSEMBLY | |
PVC REFILL TUBE | |
TANK TO BOWL COUPLING KIT #241 | |
TANK COVER | |
CLIP FOR REFILL TUBE | |
|
|
- 4 - |
