6
BOLT CAP
CLOSET FLANGE
CLOSET BOLT
WASHER NUT
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.
!CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Install caps on washers. (If necessary, cut bolt height to size before installing caps.)
c.Smooth off the bead of sealant around base. Remove excess sealant.
7a
For Tanks/Bowls using Speed Connect System (Tank mounting bolts
TANK MTG. | RUBBER | |
GASKET | ||
BOLTS PRE- | ||
| ||
INSTALLED |
|
WASHER
NUT
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washers and nuts.
b.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.
!CAUTION:
DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
7b
For all other Tanks/Bowls
RUBBER
WASHER
RUBBER
TANK MTG. 
GASKET BOLTS
WASHER
NUT
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening.
b.Insert tank mounting bolts and rubber washers from inside tank, through mounting holes, and secure with metal washers and nuts.
c.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.
!CAUTION:
DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
8 | INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions. |
|
9 | TANK | CONNECT WATER SUPPLY | |
| |||
WATER INLET |
| a. | Connect water supply line between |
|
| ||
WASHER |
|
| shutoff valve and tank water |
COUPLING NUT | FLEXIBLE |
| inlet fitting. Tighten coupling nuts |
SUPPLY |
| securely. Check that refill tube is | |
|
| ||
|
|
| inserted into overflow tube. |
| VALVE NUT | b. | Turn on supply valve and allow |
|
| ||
| COMPRESSION |
| tank to fill until water rises to |
|
| shutoff position. | |
| COLLAR |
| |
TRIM |
| c. | Check for leakage at fittings, |
|
| tighten or correct as needed. | |
PLATE |
|
| |
VALVE
10 | OVERFLOW TUBE |
TRIP LEVER |
|
| REFILL TUBE |
| Fig. 10A |
WATER CONTROL |
|
ASSEMBLY |
|
WATER LINE LEVEL |
|
| FLUSH VALVE |
| FLOAT |
| FLAPPER |
| ASSEMBLY |
WATER INLET | FLUSH VALVE |
|
ADJUSTMENTS
a.Adjust water level. Water level should be adjusted to level indicated on tank by adjusting valve height.
See Step 11 for valve height adjustment method
b.If bowl fails to siphon, an adjustment may be required with the lift chain. Simply remove the bead chain from the retainment clip (see Fig. 10A) and take up slack on the chain, and reinsert on lift rod. Make sure the chain is not too taught.
TOILET REQUIRES THAT THE TANK REFILLS IN NO LESS THAN ONE MINUTE. ADJUST WATER SUPPLY VALVE (FIG. 9) ACCORDINGLY.
- 2 - | 730451 - 100 Rev . A |
