Section II
2-12. INSTALLATION AND REMOVAL OF BATTERY.
2-13. To install or replace a battery, turn the four 1/4 turn fasteners on the battery cover on the rear of the case counterclockwise to remove the cover. Lift off the cover, lift the battery out of its recess and unplug the three-prong connector.
2-14. Reverse the above procedure when installing a new battery.
2-15. COVER REMOVAL.
2-16. To remove the cover from the instrument, release the two spring latches on either side of the instrument, then lift cover. When replacing the cover, first check the latches for released position; then place cover in position for latching. The power cord is stored inside the cover by wrapping it around the retainer fastened inside the cover.
CAUTION
DO NOT FORCE COVER INTO
PLACE. THERE IS A PROJECTION
ON THE COVER WHICH TURNS THE
POWER SWITCH TO THE OFF
Model 355B
POSITION TO PRESERVE BATTERY
LIFE. IF THIS IS NOT BINDING, THE
COVER FITS EASILY INTO PLACE.
2-17. REPACKAGING FOR SHIPMENT.
2-18. The following is a general guide for repackaging at instrument for shipment. If you have any questions, contact your local Sales and Service Office. (See Appendix for locations.)
a.Place instrument in original container if available. If not available, one can be purchased from your nearest -hp- Sales and Service Office.
b.Wrap instrument in heavy paper or plastic before placing in inner container.
c.Use plenty of packing material around all sides of instrument.
d.Use a heavy carton or wooden box to house the instrument and inner container and use strong tape or metal bands to seal the shipping container.
e.Mark shipping container with "Delicate Instrument" or "Fragile".
2-2
