| Installation |
ENFIELD | Instructions |
2373.801 | |
Spread Lavatory Faucet | 2373.821 |
with the Speed Connect™ Drain |
|
Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.
Speed Connect™ Drain*
Certified to comply with ANSI A112.18.1
• Fewer parts, installs in less time | M968301 Rev. 1 . 3 |
•Never needs adjustment
•Guaranteed to seal properly the first time, every time.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
To ensure that your installation proceeds
Recommended tools
Screwdriver | Channel Locks | Adjustable Wrench | Tubing Cutter |
1 |
|
| Turn off hot and cold water |
| INSTALL SPOUT | CAUTION | |
| supplies before beginning. | ||
|
|
|
|
Insert SPOUT (1) and CABLE CONNECTOR (14) through center hole, making sure the SPOUT ESCUTCHEON (2) and SEAL WASHER (3) are properly seated.
Assemble RUBBER WASHER (4), BRASS WASHER (5) and LOCKNUT (6) onto SPOUT SHANK (7) from under side of sink . Make sure SPOUT (1) is centered in the mounting hole and the slot in the BRASS WASHER (5) faces toward the rear of the sink.
Tighten LOCKNUT (6) firmly. Fig. A.
1A INSTALL VALVE BODY
Place RUBBER RING (9) into DECK ADAPTER (10).
Install LOCKNUT (11) and RUBBER WASHER (12) onto VALVE BODY (13). From under side of mounting surface, install VALVE BODY (13) through valve mounting holes. Threads of VALVE BODY (13) should extent at least 5/16 of a inch above mounting surface top. Fig. B. Thread DECK ADAPTER (10) onto VALVE BODY (13) until snug against internal stop. If necessary, adjust LOCKNUT (11).
Tighten LOCKNUT (11) with WRENCH (8) (supplied) to secure VALVE BODY (13). Repeat above steps for opposite VALVE BODY (13A).
Fig. A.
1
2
7
3
SLOT
4
5
6
14
| 10 | 1 |
| 10 | |
| 9 | |
| 9 | |
5/16'' MIN. | MOUNTING | |
SURFACE | 13a | |
|
| |
Fig. B. | 12 | 12 |
| ||
| 11 | |
| 11 | |
|
| |
| 13 | 13 |
8 |
|
|
1
