American Standard 192, 2506, 195 Maintenance, Handwash Sensor Operation Fig

MAINTENANCE

1HANDWASH SENSOR OPERATION; Fig. 1

When the Sensor detects a user, the water immediately starts to flow. Water flow will stop Two seconds after user is out of sensor range. The off delay allows the user to comfortably move his hands without the flow cycling on to off. As a precaution, a safety timer will turn off the water, after the sensor has been blocked for 59 seconds. The water will stay off until the blockage is removed from the detection zone.

Detection Zone: 2" - 10" (50mm - 250mm)

Default: Set at Factory 6" (150mm)

2HOW TO CHANGE SENSOR RANGE; (Factory set at 6") Fig. 2

1.Setting the Detection Zone (Distance):

Remove cover from ENCLOSURE. Disconnect GRAY SENSOR WIRE (1) from circuit board, then reconnect.

2.While the SENSOR CONTROL LED (2) is blinking slowly, place your hand 1 - 2 in. (30-50mm) in front of the sensor. Fig. 2a.

3.When the LED stops blinking and stays "ON", move your hand to the desired position and hold in place until the LED begins to blink again. Fig. 2a.

4.Once the SENSOR CONTROL LED (2) begins to blink again, remove your hand from the detection zone. When the flashing stops, the detection distance is set.

Fig 1

DETECTION

ZONE

Fig..22

1

Fig..2a Fig. 2a

1" - 2" (30mm - 50mm UP TO 10" (250mm)

2 BLINKING LED 2 BLINKING LED

3HOW TO CLEAN AND REMOVE THE AERATOR; Fig. 3

1.Remove AERATOR HOUSING (1) with KEY supplied with faucet.

3.Remove AERATOR (2) from HOUSING (1).

2.Clean the AERATOR SCREENS (3) with a old tooth brush to remove dirt.

4.Rinse Clean with water. Reassemble and install into spout end. Be sure black seal washer is in place.

1

Fig.3

3

2

6 M 9 6 5 2 74