10 TEST INSTALLED FITTING |
|
With HANDLES (1) in OFF position, turn on WATER | 4 |
SUPPLIES (2) and check all connections for leaks. | |
Remove AERATOR (3). | 1 |
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3). | 1 |
CHECK DRAIN CONNECTIONS |
|
Operate |
|
Check that DRAIN STOPPER (5) makes a good seal |
|
and retains water in SINK. If DRAIN STOPPER (5) | 3 |
does not seal properly, please refer to Troubleshooting |
section in these instructions. |
|
Release |
|
connections and "P" trap for leaks. Tighten |
|
if necessary. | 5 |
|
WASTE
OUTLET
2
2
“P” TRAP
11 | SERVICE | 1 | |
2 | |||
|
|
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove IINDEX (1) and HANDLE SCREW (2).
Pull HANDLE (3) and ESCUTCHEON (4) off.
Remove ADAPTER (5) and SPRING CLIP (6).
3
4
Lift STOP WASHER (7), turn 90˚ and replace. | 90˚ |
| |
Replace SPRING CLIP (6). |
|
Replace ADAPTER (5), ESCUTCHEON (4) |
|
HANDLE (3), SCREW (2), and INDEX (1). | 6 |
|
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90˚.
Remove AERATOR (8) and rinse clean if water flow becomes distorted.
5
7
8
12 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER.DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M968786 Rev . 1 . 3
4
