Vixel manual Management, Port Settings, Vixel Model 335 Installation & Configuration Guide

Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management

3.Click Submit to accept the changes.

4.Click Back to Port Usage to view the new settings.

Port Settings

The Port Information page displays the port status for each port on the switch.

To view the port settings, click Port. The Port Information page appears.

Figure 3-15.Port Information Page

The displayed settings are listed below:

Setting	Description
Port	The actual port on the switch.
Transceiver	The type of transceiver inserted in the port.
Trcvr LED	If a transceiver is inserted properly, the LED is on.
Fault LED	The port is bypassed due to a problem detected by either the
	transceiver’s transmit logic or the SFP transceiver itself.
	Transceiver problems include unconnected fiber, remote node
	not transmitting, LIP(F8), or a faulty transceiver.
State	The current state of the selected port.
TX	The state of the transmitter on the selected port.
Inserts	The number of times a transceiver has been inserted into the
	port since the last switch reset.
Freq	The port locked in on the communicating frequency for which
	the switch is configured.
Zone	The zone in which the port is located.
Cascade Mode	Displays the cascade mode for the specified port.
Cascade State	Displays the cascade state for the specified port.

25