Vixel Management, Configuring the Switch, Vixel Model 335 Installation & Configuration Guide

Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management

Configuring the Switch

The CLI enables you to configure the switch settings, policies, and zoning.

A list of frequent switch configuration tasks and their commands is shown here. Refer to the provided page number for more detailed information on each configuration task.

Configuration Task	CLI Command
Change the IP parameters	co
(See “Changing the Switch’s IP Parameters” on page 38.)
Change switch identification, contact, location, etc.	si
(See “Configuring Switch Information” on page 38.)
Upgrade firmware	fw
(See “Managing the Firmware” on page 39.)
Add or delete a trap destination (through the	ct
Configuration menu)
(See “Configuring the Trap Destination Table” on page 41.)
Changing the password	pw
View switch management, policies, error thresholds, and	mc
other switch settings.
(See “Viewing Management, Policy, and Threshold Settings” on
page 43.)
Change the switching mode	sw
(See “Changing the Switching Mode” on page 47.)
Configure zoning	oz
(See “Viewing and Understanding Zoning Information” on	(for overlapping zoning)
page 52.)
	noz
	(for non-overlapping zoning)
Reset switch	rs
(See “Resetting the Switch” on page 13.)
Reset switch to factory default settings	rc
(See “Resetting the Switch to Factory Default Settings” on
page 51.)
View & modify port settings	po
(See “Displaying Ports” on page 49.)
Change the switch speed	lsp
(See “Changing the Switch’s Operating Speed” on page 52.)
View the event log	ev
(See “Viewing the Event Log” on page 51.)

To view the complete list of available switch commands while using the CLI, type ? or h at the prompt. For a complete listing of all CLI commands, see CLI CONSOLE COMMANDS (APPENDIX B) on page 60.

37