Vixel Model 335 Installation & Configuration Guide | CHAPTER 3 Management |
|
|
Note: The “Destination:” message varies according to the active firmware image and the platform you are using. See Step 2.
Managing the Firmware
To view the current firmware settings and a complete list of commands, type fw at the prompt. The Internal Firmware Versions list and Firmware Menu appear:
Internal Firmware Versions:
CURRENT: | V2.01 | (build 79) | Mar 23 | 2002 | 00:48:59 | ||
ALTERNATE: | V2.00 | (build | 69) | Feb | 27 | 2002 | 17:30:42 |
BOOT: | V1.01 | (build | 55) | Nov | 9 | 2001 | 11:11:23 |
FIRMWARE MENU
1.Show versions
2.Select alternate version
3.Load new firmware via Ethernet
4.Load new firmware via serial
5.Reboot
6.Exit menu
The Internal Firmware Versions list displays the current and alternate firmware loaded on the switch. The Boot firmware is installed during the manufacturing process and manages the loading of the current firmware on the switch during
To select the alternate firmware version, type 2 at the prompt. A message appears informing you that the Alternate firmware version has been selected and will load on the next switch boot.
Downloading New Firmware
You can use either of the following available download methods for Windows; for Unix workstations, use the Ethernet (TFTP) method.
To download firmware from a binary file, type fw and choose the desired downloading method.
Ethernet (TFTP) Method (Menu Option 3)
Use the Ethernet (TFTP) method for Unix workstations (this method can also be used on Windows NT workstations).
1. Type: 3 at the prompt.
The following message appears.
Ready for TFTP file transfer
IP address: IPaddressForYourCard
Destination: ramdisk
2.For Windows:
•Use a command line to move to the directory containing the new firmware and type the following (where IPaddress is the switch’s IP address and filename is the name of the binary firmware file) and press Enter.
tftp -i IPaddress PUT filename ramdisk
Within a few seconds, the “Transfer successful” message appears. (If the message does not appear, verify that the file is good and repeat the transfer.)
3.For Unix workstations:
a.At a Unix prompt, type the following (where IPaddress is the switch’s IP address) and press Enter.
tftp IPaddressb.Type the following and press Enter. binary
c.Type the following (where filename is the name of the binary firmware file) and press Enter.
put filename /ramA message appears confirming that the file was sent.
39
