Vixel manual Management, Displaying Ports, Vixel Model 335 Installation & Configuration Guide

Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management

Displaying Ports

The Show Port command displays all information concerning a specific port and allows you to change the port policies.

To configure the currently selected port, type po at the prompt.To activate the show port command for a specific port, type po x (where x is the port number) at the prompt.

port 1	(switch ID=28000070)
	module	: none
	state	: bypassed
	zone	:	1
	PLL	:	nolock
	transceiver LED	:	off
	fault LED	:	off
	cascade state	:	none
	connect type	:	none
	insert count	:	0
	clk delta ppm	:	0
	rx frame count	:	2
	connect attempts :		0
	connects busy	:	0
	CRC errors	:	2
	bad OS errors	:	0
	port util avg	:	0
	port util high	:	0
	port util low	:	0
	port util last	:	0
(1)	Control		: auto
(2)	Beacon		: off
(3)	Transmitter		: on
(4)	Cascade mode		: tree
(5)	LIP on insert		: enabled

(6)Test before insert : disabled

(7)Overlapping zones : 0x004

(8) Util period avg : 100

(9)Util period stats : 100

(10)Reset counters

49