American Standard 2568 Caution Do Not Use, Cone Washer With, Plastic Supply Line, Install Toilet

6

BOLT CAP
BOLTS	CLOSET FLANGE

INSTALL TOILET

a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.

! CAUTION:

DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b.Install caps on washers. (If necessary, cut bolt height to size before installing caps.)

c.Smooth off the bead of sealant around base. Remove excess sealant.

7 INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

8a	Before continuing, determine the type of water supply connecation you have from
	the chart below and use the appropriate assembly parts required to properly
	reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

METAL/COPPER		METAL FLANGED		METAL SPIRAL		VINYL/BRAIDED
FLARED TUBING			TUBING	TUBING		CONNECTOR
	LOCK NUT		LOCK NUT		LOCK NUT	LOCK NUT
	CONE		EXISTING		EXISTING	COUPLING
			WASHER
	WASHER				CONE	NUT
	COUPLING		EXISTING		WASHER
			COUPLING		COUPLING
	NUT
			NUT		NUT
	WATER		WATER		WATER	WATER
	SHUT-OFF		SHUT-OFF		SHUT-OFF	SHUT-OFF
These parts must be used as			Use existing	Use existing spiral		Captive cone
illustrated to insure water-tight			coupling nut	cone washer.		washers already
connection. Use of existing			and washer.	Fluidmaster cone		included. No
coupling nut may result in				washer may not		additional washers
water leakage. Water supply				seal completely on		needed.
tube or pipe must extend at				spiral type supply
least 1/2" inside threaded				line.
shank of valve (does not apply
to flanged tubing).
	CAUTION: DO NOT USE				CAUTION: Overtightening of
	CONE WASHER WITH				LOCK NUT or COUPLING NUT
					could result in breakage and
	PLASTIC SUPPLY LINE.				potential flooding.

8b

With correct washers in place (see Step 8a), tighten COUPLING NUT 1/4 turn beyond hand tight. DO NOT OVERTIGHTEN.

- 2 - 7301270-100 Rev. A